Pillar Security Window Film Installation Instructions & POV Timelapse

Get yours from Amazon or eBay

Tools Required:
– Spray bottle
– Application Solution (or 2% baby shampoo in filtered water)
– Squeegee/Applicator
– Craft knife
– Lint-free cloth
– Straight edge
– Measuring tape

Installation:
– Thoroughly clean glass to remove all dirt and debris using an ammonia-free cleaner, scraper and lint-free cloth.
– Measure width and height of glass area to cover using a metal tape measure for accuracy.
– Allow film to relax after unrolling from tube. On a clean flat surface, cut window film 20-25mm wider than required along all sides to ensure coverage.
– Peel away backing by placing a small piece of masking tape front and back on 1 corner of film and separate.
– Apply a generous amount of application solution to glass and BOTH sides of window film to allow for easy installation.
– Place adhesive side of film against glass and gently maneuvers film into position. Smooth out bubbles by hand.
– For extra lubrication spray more application solution. Starting from top-centre, use applicator tool to work out bubbles to edges.
– Using a straight edge, trim excess film leaving a 1-2mm gap for any water residue to escape.
– Lightly spray with more application solution and work out any remaining bubbles. Use cloth to capture access moisture.
– Allow up to 14 days after installation for film to bond to glass.

#ads